Aluminium Alloy 5052 (H32,22,O) - UNS A95052

Aluminium Alloy 5052 (H32,22,O) Roundbars Available

Alloy 5052 rods & Roundbars Exporters & Supplier in Switzerland, New Zealand,Netherlands,Brazil,Colombia,Egypt, Iraq,Malaysia, Nigeria, Singapore.

Leveraging to our wide distribution network, we are able to offer our clients a dimensionally accurate range of Aluminum Alloy 5052 H32. Having excellent finishing properties, our offered 5052 is referred as anodize quality aluminum. Good resistance to corrosion, especially in salt-water/marine atmospheres, these alloys offered by us are highly applauded in the market.

Other details:

Anodized coatings are bright and clear

The major alloying element in 5052 is magnesium in sufficient quantities

Cause substantial lowering of the melting point

Do not produce brittleness

5052 is far stronger than the 1100 or 3000 series aluminiums

Forms with reasonable bend radii

WelMin 90 degree cold bend radius (for .064" thick): 1T The above values are average and may be considered as representative of 5052-H32 applications.

Technical Data Sheet
Chemical Composition Limits
Weight% Al Cu Si Fe Mn Mg Zn Cr Others
5052 Bal 0.10 max 0.25 max 0.40 max 0.10 max 2.2 / 2.8 0.10 max 0.15 / 0.35 max 0.05 max (each)
0.15 (total)

Aluminum 5052 is one of the higher strength non-heat treatable alloys (Annealed it is stronger than 1100 and 3003). Alloy 5052 has excellent characteristics with a high fatigue strength it is used for structures which are subject to excessive vibrations. As 5052 also has excellent corrosion resistance, especially in marine atmospheres and is therefore commonly used in boats, marine components, fuel and oil tubing.

Typical Mechanical Properties
Material Temper Tensile Strength (ksi) Yield Strength (ksi) Elongation % in 2" min bend radius (90° cold forming)
5052 Sheet
0.064" thick
5052-0 25-31 9.5 19 0
5052 Sheet
0.064" thick
5052-H32 31-38 23 7 1t
5052 Sheet
0.064" thick
5052-H34 34-41 26 6 1 1/2 t

For the Product information and customer service.